Free wood fence material calculator

What materials will your wood fence need?

Measure each fence run. Get a clear count of posts, rails and vertical boards for your chosen spacing and layout.

Free to use · No signup · By Daniel

Map your fence runs.

Use your own figures or try the example.

Your entries stay in this page. Refreshing clears them.

Your fence materials.

Calculated from the figures you enter.

A clear starting point
for the job ahead.

Fill in your measurements or costs to see the result and its breakdown here.

Construction Job Estimator app

Ready for the whole job?

Turn your fence quantities into a complete job estimate.

Keep the scope, materials and labour together in Construction Job Estimator.

Create an estimate in the app

Know what goes into the number.

Count bays separately for every run

Round each fenced run divided by maximum bay length up to a whole bay. Add one end post to each run, then deduct the shared endpoint posts you have identified. Gate widths are not fenced length: split the run at each gate, leaving the adjacent end posts in the count.

1

Split the fence into runs.

Enter each uninterrupted length separately, divided by commas. Exclude gate widths and start a new run on each side of a gate.

2

Set the spacing and boards.

Use the maximum bay length for your selected system, rails per bay and actual board width. Board width and gaps use inches or millimetres.

3

Review the material list.

Each run rounds independently. Check shared posts, individual rail lengths and the whole-board allowance against the physical layout.

Worked example

See the calculation
come together.

Runs of 40 ft and 24 ft at an 8 ft maximum bay length need five and three bays. Before shared-post deductions that is 10 posts. If they share one corner post, deduct one for nine posts. Two rails per bay require 16 rail pieces; each must suit its actual bay length.

Illustrative inputs. Replace them with the figures for your job.

The example breakdown

Total fenced length
64 ft
Bays (rounded separately per run)
8 bays
Posts after shared-post deduction
9 posts
Rail pieces (one per bay per rail)
16 pieces
Vertical boards including waste
156 boards

Check the details before you quote.

Use actual board width.

A nominal board size may differ from the usable width. Measure or check the product specification before estimating the board count.

Deduct shared posts carefully.

Deduct an endpoint only when two runs physically use the same post. Separate end posts beside a gate are not a shared corner.

Add gates and foundations separately.

This list covers a non-overlapping vertical-board fence. Gates, hardware, concrete, footings and fasteners need their own quantities.

Know the limits of the board allowance

Vertical boards are estimated per run from actual board width and gap, then waste is added. The calculation assumes a non-overlapping vertical-board fence; it does not support feather edge or board-on-board. Gates, hardware, concrete, footings, fasteners and structural design are excluded. End posts beside gates may need a different specification.

Common questions

Can I use this for overlapping boards?

No. The board calculation assumes one non-overlapping layer with the entered gap. Feather edge and board-on-board layouts need a different takeoff.

How do I enter an L-shaped fence?

Enter each straight run as a separate length, for example 40, 24. Deduct one shared endpoint if those runs meet at the same corner post.

Does the result specify post size or depth?

No. It counts materials from your chosen layout. The appropriate post, foundation and structural details must be established separately.

Does waste increase the post and rail counts?

No. The entered waste percentage applies only to the vertical board allowance. Add any required spare posts or rails separately.

Can I save the calculation?

Yes. Once your inputs are complete, download a CSV or use Print / save PDF. Your copy includes the inputs and calculation limits. Refreshing this page clears your entries.